Autumn Accents Ornament Wreath Tutorial

Thank you for all your lovely comments about my little autumn decoration, both on here and elsewhere on line.

As I mentioned before this was based on the Holiday Ornament decoration on the front page of the new Autumn Winter catalogue and I just used the same technique to make this.

First of all cut 20 large leaves using your Autumn Accents die and More Mustard card stock

 (you will need about 3 1/2 A4 sheets) and another 20 smaller leaves using Old Olive card stock

 (less than 2 full sheets of A4)

  

Ink all the edges using a sponge dauber. I used Pumpkin Pie ink on the More Mustard leaves and Always Artichoke ink on the Old Olive leaves. 

 

Then stamp all over each leaf using the script and water splash stamps from French Foliage. Again I used Pumpkin Pie ink and Always Artichoke ink.

WARNING! Now you may notice in the picture above that I have die cut, inked and stamped the oak leaf, which was fine and dandy until I realised that it wasn't symmetrical and that I couldn't fold it in half to make a mirror image - whoops!

 

So then I die cut another twenty of the smaller leaves - now these are not quite symmetrical either but they are close enough that when you ink the edges you don't really see the bits that don't quite line up.

If you really wanted to use the oak leaf you could do this by folding your card in half BEFORE running it through your big shot. If the fold of your card runs down the middle of any of the leaves then you will end up with a mirror image leaf.
Then I took 5 of the More Mustard leaves and 5 of the Old Olive leaves and set them to one side. I scored the remaining 15 leaves in each colour down the centre using my Simply Scored tool.

 
 HELPFUL TIP!: You might notice that I have marked lines on my Simply Scored. This makes it easier to make sure you are scoring the correct line as the Simply Scored has so many grooves on it. I just used a Stampin' Write marker and ran it down the 2", 4", 6", 8" and 10" lines.

Now you need to fold all your scored leaves in half

 

Glue the three folded leaves together, making sure the shape lines up, and then glue these on to your unscored leaf base. I used my tombow liquid glue for this.
 

Once your leaf is assembled it should look like this.

Then I used the largest flower from the Fun Flowers die as a base. You don't need to do this but I found it helpful as it has 5 petals so it makes it a bit easier to place your leaves evenly. The next one I make I would probably put the leaves a smidgen nearer the middle than shown in the photo below.
I used a hot glue gun to attach the leaves at this stage.

I then cut 5 lengths of Cherry Cobbler Scallop Tulle ribbon - about 4 scallops long in each case and sort of pinched the middle and folded them in half before gluing them in the spaces between the 5 larger leaves using my glue gun.

I then cut 5 lengths of linen thread, folded them in half, and tied a knot. Use your glue gun to place a large dollop of glue in the middle of your wreath and then add the linen thread so it more less lines up over the large leaves.

Add another large dollop of glue in the middle and add the Old Olive leaves.
A mini rosette was made using a 1/2" strip of paper cut from the Candlelight Christmas Speciality DSP and finished off with an antique brad.

To finish it off I cut a small length of Old Olive 1/8" Taffeta Ribbon and glued this on the back to make a loop to hang the wreath up.

Hopefully that is clear but if you have any other questions please do let me know.